• Discussions

  Need X-pert Help!

  Posted by sailor on September 4, 2012 at 12:32 pm

  My pole was good and static yesterday, but after my work out it now turns about a half inch and then stops. I don't atually know how to put it in spin mode. Can someone help me?

  sailor replied 12 years, 2 months ago 2 Members · 2 Replies
• 2 Replies

• 

  Dancing Paws

  Member

  September 4, 2012 at 3:03 pm

  1) Thighten the two bottom screws right above the base. They must be aligned with the x's on the base. 2) If that doesn't work, tighten the 3 screws above the adjuster cover (they must be on the flat part of the adjuster rod NOT the threads!) 3) If those both don't fix it, tighten the two screws under the aduster cover. Whenever I had turning issues, it usually was those two screws being the culprit.

• 

  sailor

  Member

  September 4, 2012 at 7:13 pm

  THANK YOU!!

  It was both the bottom two screws that line up with the X's and the 3 set screws. I dropped the cover and double checked that I was not on the threads, it was fine just not tight enough.

  Thanks again!! 😀

Log In to Reply