StudioVeena.com Forums Discussions Can’t get my X-pole up

  • Can’t get my X-pole up

    Posted by Vendetta on August 30, 2022 at 1:15 am

    I cannot get my X-pole up to save my life. Without the extender, the pole overextends. With the extender, it hits the ceiling and I can’t get it straight. I gave up after not being able to get the top piece that connects to the dome off of my pole. I tried calling X-pole, but they’re closed right now. Any advice?

    Blaqkxmassacre replied 2 years, 3 months ago 3 Members · 5 Replies
  • 5 Replies
  • Vendetta

    Member
    August 30, 2022 at 2:50 am

    Update: can’t get the top insert out now. I give up🏳️🏳️🏳️🏳️

  • Veena

    Administrator
    August 30, 2022 at 1:33 pm

    Is there a smaller extension you can buy?

    The top stem can be hard to pull put. Try hitting it with a rubber mallet on the sides (cover it with a cloth) to loosen it.

  • Vendetta

    Member
    August 30, 2022 at 1:35 pm

    I’ll try the mallet! The 125mm extension SHOULD work because my ceiling is 8’1″ which is why I’m so confused. I might need to see if there’s an extension in between.

  • Veena

    Administrator
    August 30, 2022 at 1:41 pm

    I had issues with the new style xpoles not fitting as I expected either. 😐 not sure what they changed.

  • Blaqkxmassacre

    Member
    September 6, 2022 at 1:48 am

    I had the same problem. If you go to technical support on the xpole site they have a height chart. It sounds like youre only going to be able to use the a and b pole and the 125mm ext and the little connect to the base. I had to read the instructions at least 5 times before i understood. Also, you have to unscrew the screws at the bottom near the static/nonstatic part (if you have that) two turns and then spin the pole in static to use the extension. Make sure you read the full instruction part.

Log in to reply.