• Discussions

  Gap between x pole tubes

  Posted by rosebloom637927 on October 19, 2018 at 4:45 am

  Hi everyone!
  I just got my pole in earlier this week and no matter what I do, I can’t seem to get my a pole to be flush against the 750mm extender (I have super low ceilings). I had the same issue with my b pole when I was waiting for my extension to come in. The joint is closed as tight as I can get it, but no matter which one I use, the peices do not fit together quite right! It’s to the point where I can only access one of the hex screws because the alignment is off.
  Appreciate any help you guys can give

  

  Veena replied 6 years, 3 months ago 2 Members · 1 Reply
• 1 Reply

• 

  Veena

  Administrator

  October 20, 2018 at 4:59 pm

  I would contact xpole.

Log In to Reply