StudioVeena.com Forums Discussions My X-pole keeps slipping?

  • leyrose

    Member
    August 20, 2013 at 10:03 pm

    mine is on carpet too and I didn't measure it or anything… I was determined to get it up without the help of a male so I did it in like 20 mins and mine is fine. It sometimes gets loose so I just tighten it up a bit. 

  • michaelaarghh

    Member
    August 20, 2013 at 10:16 pm

    So now it’s not slipping at all hooray!!! It’s just very creaky….hmmmmm haha

  • moonlitmare

    Member
    August 21, 2013 at 10:43 am

    Mine creaks too…only in one spot of the spin. I thought maybe it was because the pole was 100% perfectly vertical, it mostly is. I'm not good enough to be on spin so its not a huge issue for me. I do have to say when I did try spin the creak drove me nuts.

    I also had to put a board below my pole because I'm on the 2nd floor. The pole was not settling even into the carpet as I tightened it. I was afraid the base might bust through the floorboards.

  • leyrose

    Member
    August 21, 2013 at 4:29 pm

    Mine creaks too!
    And I find it spins so so much faster than the permanent ones at my studio… I sort of have my screws tightened half way between spin and static. Although, even when mine is on static it still spins a bit :/

Page 2 of 2

Log in to reply.