• Discussions

  Spinning pole question

  Posted by Nat on April 6, 2018 at 11:50 am

  Hi all,
  I think I may have overtightened my pole. When I start climbing it spins very fast but the minute I try to switch positions it just stops. When at my studio I can do different positions without a problem but on mine it does not work. Can someone tell me if I spin it with my hands without actually getting on it, and let go should it carry on spinning for little longer? Mine just stops immediately. Thank you

  Nat replied 6 years, 8 months ago 3 Members · 3 Replies
• 3 Replies

• 

  Autumn Sky

  Member

  April 7, 2018 at 11:50 am

  I have an x-pole expert, and if i over tighten it while screwing it into my permanent mount, it does exactly as you described. One turn of the pole in the opposite direction usually fixes the problem.

• 

  chemgoddess1

  Member

  April 8, 2018 at 12:10 am

  There is also a possibility that your pole is not straight. Did you check the level on 2 planes?

• 

  Nat

  Member

  April 8, 2018 at 6:06 am

  So I have now tried to loosen it and checked again if it’s straight. It’s not perfectly straight but it will not get any better. Still the same problem. Contacted the xpole helpline, so I suppose will have to wait till tomorrow now to get a reply x

Log In to Reply