• Discussions

  xjoint problem

  Posted by Flexx10 on January 11, 2012 at 9:22 am

  I've been using my xpole on spin mode for while now with no xjoint problems ~ So yesterday I put it on static, did ONE spin and  now the joints are out of alignment. One has no holes showing at all. I've seen threads on here regarding xjoints before, but never really paid attention to them because I've never had any trouble…. Any suggestions to fix the problem? Thanks!!

  Anonyma replied 13 years, 3 months ago 4 Members · 4 Replies
• 4 Replies

• 

  amy

  Member

  January 11, 2012 at 9:25 am

  Try "unspinning" the pole around the joint by doing spins in the other direction. if that doesn't work, take the extension off that you are able to, and pound the joint out with a broomstick.

  fyi, you should check the joints every time you use the pole to make sure that they are as tight as possible… they can loosen over time, which may be what caused your problem.

• 

  Flexx10

  Member

  January 11, 2012 at 9:42 am

  Thanks Amy!

• 

  chemgoddess1

  Member

  January 11, 2012 at 11:19 am

  XPole also has videos on their website.

• 

  Anonyma

  Member

  January 11, 2012 at 12:14 pm

  if it doesnt work, put a solid stick in the tube and it will push the joint out

Log In to Reply