Replies – Forums – Sprocket

Forum Replies Created

Sprocket

Member
February 11, 2019 at 8:45 am in reply to: where is everyone from?

London, England.

Spent time in Bristol and Bournemouth too =)
Sprocket

Member
April 22, 2018 at 1:25 pm in reply to: Your favorite Pole music!

Fire rides
MÃ˜

Whippen (feat. Felix snow)
Kiiara

Take yo’ praise
Camille yarbrough

Heart shaped box
Goldfish

Mama’s gun
Glass animals

Divinity – mazde remix
Kucka
Sprocket

Member
April 21, 2018 at 6:03 pm in reply to: Any New England Polers?

…. I’m a new poler… in England…. Not quite the same… but close!
Sprocket

Member
April 21, 2018 at 5:59 pm in reply to: Issue with aligning x pole

I spoke to X-pole, and they said as long as the screws are correctly tightened, and it does not move any more, it is fine. =)
Sprocket

Member
April 5, 2018 at 5:02 pm in reply to: Poling After the 30 Day Starter Program

THanks. That makes allot of sense.
Sprocket

Member
April 2, 2018 at 9:32 am in reply to: Poling After the 30 Day Starter Program

I felt that way too! There are so many great videos! But I have not done the 30 day program so I am lucky that I can start there. I’m going to start today 🙂
Sprocket

Member
April 2, 2018 at 9:20 am in reply to: Issue with aligning x pole

Great! That makes me feel allot better.

I’m actualy a maker and work with lots of engineers and me and a friend both looked at it and decided it was fine. I took the screws out and I can see it’s still lining up with a flat bit.

Thanks for the support!
Sprocket

Member
April 1, 2018 at 9:13 pm in reply to: Issue with aligning x pole

It is brand new though. I decided the same though, it’s probably ok. It has moved a bit.

I messaged pole x to see if they had anything to suggest.
Sprocket

Member
April 1, 2018 at 7:30 am in reply to: Issue with aligning x pole

I have tightened all the screws and it actually becomes un aligned as I tighten them. See it’s a little off. Now I’m actually concerned I’m doing them too tight!